Triple Time Stamping Cards

I hope that you'll find the photo instructions for creating a triple time stamped card easy to follow and useful.  I tried to be as thorough as I could be.

Supplies that I used to create this card are white cardstock, white card base (4 1/4" x 5 1/2" ), lagoon cardstock, paper trimmer, inks (Outdoor Denim, Lagoon, Pear and Slate), Bitty Sparkles, Blue & Green Epoxy Bubbles and stamp set C1583 "Robot Family".

Alright ..... here we go!!!!!!

Cut 3 rectangles.  Measurements are 3 3/4" x 5" for the bottom layer.  Middle layer is 3 1/4" x 4 1/2".

Top layer is 2 3/4" x 4" 

**You can make these whatever size you need to suit your project, I just bring the measurements down by 1/2" on both sides for each layer**

I wrote the size on the pieces just for your reference.  I don't normally write the size but I figured they'd be on the back so it wouldn't show.  In this picture, you can see how I added a small strip from my ATG gun on the back of the middle piece.  I always tap my finger on it several times so that it isn't too sticky ... you need to be able to take them apart without tearing your project.

Next you're going to center the middle white piece on top of the biggest white piece that you have cut out.

Again, just showing the small amount of adhesive that is used to temporarily secure the 3 pieces while you're stamping.  It's best to use a tape runner/ATG gun for this so that  pieces can be easily taken apart.

Now that you've put the top piece on the stack, it should look like this.

Now comes the fun part :) This is where you'll decide how you want to stamp your card.  I chose to put my sentiment in the middle.

The important part when you're stamping is that you want your image to span over the various layers.  If there is a small space from where the layers are it's ok.  The mats that you're going to make will hide that!

Adding a variety of images over the various layers.

Now my card is fully stamped. 

Your next step is going to be to separate the pieces to mat them.

I don't know the exact measurements of the mats.  I just place the stamped piece in the corner of my paper that I'm going to mat on and eyeball cut the mat using my paper trimmer.  I LOVE the guide on the CTMH Fiskars trimmer for this!

You can see here what I was talking about by placing it in the corner & trimming.

Once your second layer is matted, place in on top of the bottom layer.  Make sure that your images line up correctly before adding adhesive.  You'll want them to stay put so use ample adhesive.

All 3 layers are matted and the card is assembled.

Then attach the stamped images to your card base and embellish! Super cute and SO MUCH EASIER to do than people will think!!!

I hope that this has made it easy for you to create your own triple time stamped card!  If you would like any of the supplies that I have used to create this card you can visit my website at www.craftedworks.ctmh.com and purchase the items from there!  

Thanks for stopping by and happy scrapping!